Thermal Spray Aluminium

Alloy Designations		Chemical Composition % (Maximum Amount)
Purity	Chemical Symbols	Si	Fe	Cu	M N	Mg	Cr	Ni	Zn	Ga	V	Ti	Other	Al
99.80%	EN-AW-E Al 99.80 (A)	0.15	0.15	0.03	0.02	0.02	–	–	0.03	0.03	0.03	0.02	0.02	99.80*
99.90%	EN-AW Al 99.90	0.07	0.07	0.02	0.01	0.01	–	–	0.03	0.03	0.05	0.01	0.01	99.90**

Table 1.3

*Minimum guarantee 99.75
**Minimum guarantee 99.85

Image 1.4

During the process of feeding our wire to the metallization machine, we recommend holding the superficial tower by hand to avoid the spring effect (where the tower is out of place). Refer to Image 1.4, for the correct way to hold the tower.

To avoid the spring effect, refer to Image 1.1
Avoid cross wires in the feeding process
Avoid dropping the bobbin during handover
– which may cause the coil to break
For the correct and wrong way to lift our coils, refer to Image 1.5

Image 1.5

The product must be kept dry and protected from the elements (rain, etc.). It is recommended to keep it well in the original packaging to protect it from dust and other foreign substances

Our recommended shelf life for our aluminum wire is 6 months, we recommend using the material no later than 6 months for optimal quality.

It is advisable to wear safety glasses / googles and suitable gloves.
It is advisable to wear protective shoes.
It is recommended not stack rolls out of their original packaging. Dropping the roll may cause an impact.
Local security rules are in place and must be followed. The manufacturer will not be liable for any damage due to improper use of the submitted material.

Image 1.6

Type	External Width (mm)	Inner Diameter (mm)	Outer Diameter (mm)	Drum Diameter (mm)	Traverse (mm)	Cap Load (kg)
AJM-280A	80	18	280	150	66	6
AJM-280F	75	20	280	130	65	6-7
AJM-305	67.5	38.5	305	130	55	6.5
AJM-310	82	40	310	120	71	9
AJM-320R	63	51	320	125	51	8
AJM-320	82	51	320	125	72	10
AJM-360	65	51	360	97	56	10-11.8